Stainless steel exhaust pipes and weld bends

304 stainless steel exhaust pipes and weld bends from 32 mm to 154 mm. In 15°, 30°, 45°, 60°, 90° and 180°. Precise dimensions for custom exhaust systems.

About this category

Stainless steel exhaust pipes and weld bends

The foundation of every custom exhaust system. Our weld bends and straight pipes are made from 304 stainless steel with a smooth inner wall for optimal gas flow. Available in diameters from 32 mm to 154 mm and wall thicknesses from 1,5 mm to 2,0 mm.

Available diameters and applications

  • 38 mm / 1.5 inch — smaller engines, return lines, wastegate dumps
  • 50,8 mm / 2 inch — light power, catback systems for naturally aspirated engines
  • 63,5 mm / 2.5 inch — the standard for most catback systems, suitable up to ~300hp
  • 76,1 mm / 3 inch — the most popular size for turbo downpipes and performance catbacks up to ~500hp
  • 89 mm / 3.5 inch — big turbo setups and high-performance applications
  • 102 mm / 4 inch — extreme power levels (600hp+), thick-walled pipes for drag and time attack

Available angles

Weld bends are available in 15°, 30°, 45°, 60°, 90° and 180°. The bend radius varies by diameter — see the product page for exact R values. Straight pipes are available by the meter.

Two construction types

  • Slip-fit (clampable) — one end is slightly narrower so pipes and bends can slide into each other and be secured with a clamp. No welding needed, ideal for quick installation and removable systems
  • Butt-weld — both ends have the same diameter. Intended to be welded together with TIG or MIG. A stronger, permanent joint, the choice for racing and performance applications

Mechanic's tip: prevent sugaring when TIG welding

Welding 304 stainless steel? Always use an argon back purge on the inside of the weld. Without this protection the inner wall oxidizes immediately — this causes sugaring (a cauliflower-like structure), which restricts flow and eventually causes corrosion. A simple method: seal one end with tape, feed argon in from the other side and leave a small opening for venting. Not sure? Contact us — we're happy to help.

Choosing wall thickness

For most street applications a 1,5 mm wall thickness is enough — it is lighter and easier to work with. Choose 2,0 mm for applications with high mechanical loads (e.g. at the turbo manifold or where the pipe acts as a supporting structure).

Frequently asked questions

Which diameter and material should I choose?
Choose the pipe diameter based on your power goal and use stainless steel for durability; weld bends make tight routing possible.
What is mandrel bending?
Pipes bent over a mandrel keep their full diameter through the bend, for minimal flow losses.
Can the pipes be welded?
Yes, stainless steel exhaust pipes and weld bends are meant to be (TIG) welded into a custom-fit system.