What is the problem with the TFSI timing chain?
On the first and second generation EA888 (roughly 2008 to 2013), the original chain tensioner cannot always keep the chain tight enough, especially in the first seconds after starting, when there is no oil pressure yet. As a result the chain can jump a tooth. The valves then hit the pistons, causing major engine damage.
On top of that, the chain stretches over the years. Many of these engines also consume oil, and a low or contaminated oil level speeds up wear of the chain and tensioner.
Which cars have this engine?
- Volkswagen: Golf 6 GTI, Scirocco, Passat (B6/B7), Tiguan 2.0 TSI, Jetta
- Audi: A3 (8P), A4 (B8), A5, TT (8J), Q5 1.8/2.0 TFSI
- Seat: Leon (1P) FR and Cupra, Altea, Exeo
- Skoda: Octavia RS (1Z), Superb (3T), Yeti 1.8 TSI
Not sure which engine your car has? We can look up the engine code using your registration number.
When should you have the chain checked?
- Rattling or clattering in the first seconds after a cold start
- Fault codes for camshaft/crankshaft correlation (for example P0016)
- The car has high mileage and there is no proof the tensioner has already been replaced
- You are planning a tune or a turbo upgrade: then you want to be sure the basics are right
How do we tackle it?
- Measure: with diagnostic equipment we read out the camshaft deviation. That shows how far the chain has stretched, without opening up the engine.
- Advice: replace or not needed yet, honest and well-founded.
- Replace: chain(s), tensioner (the improved version), guides and, where needed, sprockets, using the correct locking tools.
- Check: read out again and test drive.